Initial commit: Simple Sensor firmware for Heltec T114 with BME280

- MeshCore-based Simple Sensor firmware
- Heltec T114 without display
- BME280 sensor support (temp/humidity/pressure)
- Radio: 868.856018 MHz, SF7, BW62.5 kHz, CR4/7
- 2-byte path hash
- PlatformIO project

examples/companion_radio/NodePrefs.h

@@ -0,0 +1,37 @@
+#pragma once
+#include <cstdint> // For uint8_t, uint32_t
+
+#define TELEM_MODE_DENY            0
+#define TELEM_MODE_ALLOW_FLAGS     1     // use contact.flags
+#define TELEM_MODE_ALLOW_ALL       2
+
+#define ADVERT_LOC_NONE       0
+#define ADVERT_LOC_SHARE      1
+
+struct NodePrefs {  // persisted to file
+  float airtime_factor;
+  char node_name[32];
+  float freq;
+  uint8_t sf;
+  uint8_t cr;
+  uint8_t multi_acks;
+  uint8_t manual_add_contacts;
+  float bw;
+  int8_t tx_power_dbm;
+  uint8_t telemetry_mode_base;
+  uint8_t telemetry_mode_loc;
+  uint8_t telemetry_mode_env;
+  float rx_delay_base;
+  uint32_t ble_pin;
+  uint8_t  advert_loc_policy;
+  uint8_t  buzzer_quiet;
+  uint8_t  gps_enabled;      // GPS enabled flag (0=disabled, 1=enabled)
+  uint32_t gps_interval;     // GPS read interval in seconds
+  uint8_t autoadd_config;    // bitmask for auto-add contacts config
+  uint8_t rx_boosted_gain; // SX126x RX boosted gain mode (0=power saving, 1=boosted)
+  uint8_t client_repeat;
+  uint8_t path_hash_mode;    // which path mode to use when sending
+  uint8_t autoadd_max_hops;  // 0 = no limit, 1 = direct (0 hops), N = up to N-1 hops (max 64)
+  char default_scope_name[31];
+  uint8_t default_scope_key[16];
+};